Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Bay Ridge
If your chimney cap is rusted through and the crown above it is cracked, water is already finding a way into the flue. We handle chimney cap and crown work throughout Bay Ridge, from the numbered streets up toward the Ridge, and we know why these components fail faster here than almost anywhere else in Brooklyn. Salt air off the Narrows, a century of freeze-thaw, and rooftops packed close enough to shake hands with the neighbor’s. We answer 24/7 and run fast dispatch from 7am to 7pm. Call (855) 551-0049 to book a free estimate.
Why Bay Ridge Homeowners Call Chimney Sweep Bay Ridge for Chimney Cap & Crown
We’re a chimney-only specialist, not a general contractor who adds cap work to a long list. That focus shows in the materials we bring: stainless and copper caps from Olympia Chimney and Famco, crown coatings from Gelco, and HeatShield ceramic resurfacing when a flue needs restoration rather than replacement. Our technicians have up to 11 years of experience.
Bay Ridge homeowners call us because we tell them what we find and nothing more. On the tight attached and semi-detached blocks off Shore Road and along the numbered streets, a cap job is often a roof-to-roof job, and we protect the neighboring parapet and any skylights before setting a single piece of hardware. That care is why the same company that inspects your chimney can also repair and restore it, with no handoff to a second contractor who never saw the original report.
We know this housing stock. We know the original masonry chimneys that came with the 1900s – 1930s brick rowhouses, and we know that a chimney that looks fine from the yard is often pitted and rusted through at the collar. Estimates are free, the price is set per job by the written estimate, and nothing gets recommended that we haven’t documented with camera evidence you can see yourself.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Bay Ridge
Cap Replacement in Bay Ridge
Most of the caps we replace in Bay Ridge were galvanised and put up decades ago. Damp Atlantic air off the Narrows pits that steel, seizes the screen, and rots it through where the collar meets the flue. A stainless or copper replacement from Olympia Chimney or Famco sized to the actual tile openings lasts far longer in this exposure, and it’s the fastest way to stop water and animals from getting in.

Crown Repair in Bay Ridge
Original mortar crowns on century-old rowhouse chimneys crack and spall from repeated freeze-thaw, and once that happens meltwater tracks down past a cracked terracotta flue liner. We rebuild crowns with a proper sloped surface that sheds water away from the stack rather than letting it pool at the tile. On tight numbered-street blocks, that work often means roof-to-roof access with careful protection of shared parapets.

Crown Coating in Bay Ridge
Not every crown needs to come down. When the mortar is sound underneath and the damage is mostly surface cracking, a Gelco crown coating reseals it and buys years before a rebuild. We check the crown by hand and by camera before recommending coating over replacement, because we’d rather coat a salvageable crown than sell you a new one.

Cap Installation in Bay Ridge
A new cap has to be sized to the flue, not grabbed off a shelf. On these old chimneys the tile openings are rarely uniform, and a loose-fitting cap rattles and lets water in at the edges. We measure, then set a stainless or copper cap from Famco or Olympia Chimney that fits the stack tightly and vents correctly for the appliance it actually serves.
Multi-Flue Cap and Custom Cap Work in Bay Ridge
Many Bay Ridge chimneys carry more than one flue, and a shared or orphaned flue needs a multi-flue cap sized to the whole stack, not a collection of singles strapped on. Where the roofline or parapet makes a standard cap impossible, we build to fit. This is also where our DuraFlex flexible liner capability matters, because offset and bent flues in old Brooklyn brick are common and rigid-liner installers often walk away from them.
Trusted Brands We Service in Bay Ridge
We work with professional chimney brands that generalists rarely stock or spec. Olympia Chimney and Famco supply the caps we set on Bay Ridge stacks, Gelco coatings seal the crowns, and HeatShield ceramic resurfacing handles cracked liner walls without a full reline. Where a flue has bends or offsets, DuraFlex flexible liner systems let us retrofit a chimney that rigid liner work can’t reach. Working with these brands means we specify the right material for the actual conditions on your roof rather than whatever happens to be on hand.
Common Chimney Cap & Crown Problems We See in Bay Ridge Homes
- Corroded, seized caps. Galvanised caps and screens rust through quickly in the salt-laden air off the Narrows, so a cap that looks sound from the yard is often pitted and rusted at the collar. By the time the screen seizes, water and animals are already getting past it.
- Cracked and spalling mortar crowns. The original crowns on 1900s – 1930s rowhouse chimneys have been through a century of freeze-thaw. Once the mortar cracks, meltwater runs down past a cracked terracotta flue liner and shows up as a stain on a ceiling two floors below.
- Loose flashing at the chimney-roof joint. On tightly packed semi-detached roofs, flashing pulls away and water migrates along shared parapets instead of showing up at the chimney itself. That makes the leak hard to trace without someone who knows these roofs.
- Sealed or converted fireplaces. Many fireplaces on these blocks were sealed or converted decades ago, so the flue under a corroded cap may not serve the firebox you assume it does. We camera-inspect to confirm which appliance a flue actually serves before any cap or crown work begins.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Bay Ridge, NY
A typical cap replacement in Bay Ridge runs $275 – $650, and a multi-flue cap for a two-flue stack usually lands between $450 and $900. Crown repair on a century-old rowhouse chimney typically runs $400 – $1,100 depending on how much mortar has to come out and whether the flue tiles need attention underneath. Crown coating, when the mortar is sound, usually falls in the $300 – $600 range. Stainless and copper caps cost more than galvanised ones up front, but in this salt air they last long enough to more than earn the difference. Every price is an estimate, and the written estimate sets the final price. Estimates are free, so call (855) 551-0049 and we’ll walk your roof and quote it straight.
We Also Serve Cities Near Bay Ridge
Our chimney cap & crown team works across the neighborhoods around Bay Ridge, including Dyker Heights, Borough Park, Sunset Park, and Bensonhurst. The same century-old brick, the same freeze-thaw, and the same roof-access challenges carry over into those blocks. If you’re just over the line from Bay Ridge, call (855) 551-0049 and we’ll quote your cap or crown job.
Serving Bay Ridge, NY – Our Local Coverage Area
We serve Bay Ridge and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Bay Ridge
Salt air off the Narrows is the main reason. Damp Atlantic air pits galvanised steel and seizes the screen years ahead of what you’d see a few miles inland, and winter freeze-thaw works the collar loose until water gets past it. Swapping to a stainless or copper cap from Olympia Chimney or Famco is the fix, and it lasts far longer in this exposure. Call (855) 551-0049 for a free estimate.
It depends on whether the mortar under the cracks is still sound. Surface cracking on a solid crown can often be sealed with a Gelco coating, which is the less expensive route at roughly $300 – $600. If the mortar has spalled deep or the crown has lost its slope, a rebuild in the $400 – $1,100 range is what actually sheds water. We check by hand and camera before recommending either. Call (855) 551-0049 for a quote.
Yes, and more so on a coastal block than inland. Even an unused flue takes on water through a cracked crown or failed cap, and that water tracks down past old terracotta tiles and shows up as a stain indoors. Birds and squirrels also nest in an open or broken flue. A yearly look catches all of that before it becomes a repair. Call (855) 551-0049 to book an inspection.
It’s common in Bay Ridge. Many fireplaces on these blocks were sealed or converted decades ago, which leaves the original flue serving an appliance you may not realize is connected, or serving nothing at all. We camera-inspect the flue to confirm what it actually serves before touching the cap or crown. Call (855) 551-0049 for a free estimate.
A single-flue cap covers one tile opening; a multi-flue cap covers the whole stack in one piece. Old Bay Ridge chimneys often carry two or more flues, and a single multi-flue cap sized to the entire stack from Olympia Chimney or Famco seals better and holds up longer than several singles strapped on separately. Multi-flue caps typically run $450 – $900 here. Call (855) 551-0049 for a quote.
Book Your Chimney Cap & Crown Estimate in Bay Ridge
A rusted cap or a cracked crown is a slow leak into your flue, and in this salt air it stops being slow faster than you’d think. Call (855) 551-0049 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. We’ll get on your roof, camera-inspect the flue, and tell you straight whether the work can wait or needs doing now. Nothing gets recommended without evidence you can see for yourself.
Written by the team at Chimney Sweep Bay Ridge.