Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Repair Across St. George
If your chimney is shedding brick, leaking at the flashing, or showing crumbling mortar joints, you’re looking at a repair – not a replacement. In St. George, chimney repair typically runs from a few hundred dollars for repointing a small section up to several thousand for a partial rebuild, and the written estimate you get before any work begins is the price you pay. We’re Chimney Sweep Bay Ridge, a chimney-only company, and St. George is one of the neighborhoods we know block by block. The housing here is dense and often old: pre-1950 detached houses and low-rise apartment buildings with original brick chimneys, many with clay-tiled or unlined flues. That stock needs hand-sweeping and camera verification, not a high-speed rotary brush run through and out. Call (855) 551-0049 and we’ll set up a free estimate – we answer 24/7, with fast dispatch from 7am to 7pm.
Why St. George Homeowners Call Chimney Sweep Bay Ridge for Chimney Repair
St. George sits on the north shore of Staten Island, where the humid coastal air and freeze-thaw winters work on masonry all year. Water gets into a hairline crack in the crown, freezes overnight, expands, and pops the face off a brick. Repeat that a few hundred winters and you have spalling. When we look at a chimney in St. George, we’re not guessing at what happened – we’re reading the pattern of it. Our technicians have up to 11 years of experience, and on shared stacks that experience matters. We’ve learned to check the offset flues and the party-wall construction that rowhouse blocks here depend on.
We come out to St. George regularly, from the blocks near the ferry terminal to the streets climbing toward Grymes Hill, so we know the roof access, the tight side yards, and the way chimneys get tucked between buildings. The first thing we do is inspect with a camera. Nothing gets recommended that you can’t see for yourself on the monitor, and we’ll tell you plainly when work can safely wait. That’s how we run every job here.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Repair Services in St. George
Repair work in St. George usually falls into a handful of categories, and the right order to tackle them depends on what the inspection shows. Here’s what we handle most often.
Mortar Repointing in St. George
When the mortar joints between bricks erode, the brick itself starts taking the weather. Repointing means grinding out the failed mortar and packing in new mortar matched to the original. The right mix matters more than most people realize. A mortar that’s too hard traps moisture inside the wall and accelerates spalling – a real risk on St. George’s older masonry, where the original lime mortar was softer than the modern portland mixes some contractors reach for. We match the mortar to the building, not the other way around.

Spalling Brick Repair in St. George
Spalling is when the face of a brick flakes off, leaving a rough, porous surface that absorbs water faster than the next freeze can push it out. On St. George chimneys, it usually shows up on the side facing the prevailing weather, and it often starts below a failed crown or flashing where water has been getting in. We cut out the damaged bricks, replace them with matching units, and fix the source of the moisture so the new brick doesn’t go the same way.

Chimney Waterproofing in St. George
After the masonry is sound, a breathable waterproofing sealant on the stack and crown slows water absorption without trapping vapor inside. In St. George’s humid coastal climate, that balance is the whole point. Sealant on deteriorating masonry just locks the problem in; done after repointing and brick replacement, it’s what keeps the repair holding up through the next stretch of freeze-thaw winters.

Flashing Repair in St. George
Flashing is the metal where the chimney meets the roof, and it’s one of the first places water finds its way in. Failed flashing shows up as staining on the ceiling below, damp masonry, or rust streaks on the stack. We replace the flashing and counter-flashing with materials suited to the roof, sealed into the masonry so water sheds away from the joint instead of sitting in it.
Trusted Brands We Specify in St. George
We work with a curated roster of professional chimney industry brands, including DuraFlex, Gelco, Olympia Chimney, and Copperfield, and we specify the right material for the job rather than the first thing on the shelf. For liner cracks that don’t warrant full replacement, we use the HeatShield ceramic resurfacing system – a specialist-grade repair option many general contractors simply can’t provide. DuraFlex flexible liners let us retrofit chimneys with bends or offsets that rigid liners won’t fit. When a repair needs a new crown or cap, we work with Famco and Olympia Chimney components. We don’t stock parts on a truck or run a local warehouse. What we bring is a working knowledge of which product fits your flue, and a written estimate that says so.
Common Chimney Repair Problems We See in St. George Homes
- Shared stacks with offset flues. On many St. George rowhouse blocks, adjacent buildings share a chimney stack, and an offset flue can leak smoke – or carbon monoxide – from one unit into the next when the liner is cracked or the smoke chamber has deteriorated. We check the party-wall side as carefully as the street side.
- Freeze-thaw spalling on the outer brick. Water gets into the brick face, freezes, and pushes it off. Repointing with a mortar that’s too hard makes it worse by trapping moisture in the wall. We match the mix to the original.
- Abandoned flues in 19th-century buildings. Chimneys that have sat dormant for decades hide broken flue tiles, soot-fall, and the occasional raccoon nest. When someone reconnects an appliance, draft failures follow. A camera inspection finds this before it becomes a hazard.
- Failed crowns and flashing. These are the two most common points of water intrusion, and fixing them early is what prevents the repointing and rebuilding work later. In St. George’s climate, water is the main driver of chimney decay.
Why St. George’s Shared Stacks Need Extra Care
This is the part of St. George chimney work that a generic repair page never addresses. On dense rowhouse blocks, a single brick stack often serves two buildings. That means a repair on one flue isn’t just your job – it involves coordinating roof access with your neighbor, checking that the flues are offset correctly, and verifying with a camera that neither unit is venting into the other. On a typical St. George rowhouse, a homeowner notices crumbling mortar and spalling brick on a shared stack. The usual cause is decades of freeze-thaw cycling and water intrusion through a failed crown or flashing, which has also compromised the clay flue liner. A qualified local pro will run a Level 2 inspection with a camera to check for offset flues and cross-contamination, then repoint the mortar, replace the spalled bricks, and apply a waterproofing sealant to the crown and stack. Coordinating access with the neighbor keeps both flues working. A cracked liner or deteriorated smoke chamber in a shared stack can let smoke and carbon monoxide from one unit seep into the other. That’s why we schedule repair work around the neighbor’s roofline when we can, and why the camera inspection comes first. If you’re on a rowhouse block in St. George, ask us about shared-stack coordination when you call.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Repair in St. George, NY
Chimney repair in St. George is priced per job, and the written estimate you approve before we start is the final price. Typical ranges for the work we do here:
| Service | Typical Cost |
|---|---|
| Mortar repointing (small section) | $350 – $900 |
| Mortar repointing (full stack) | $900 – $2,200 |
| Spalling brick repair (few bricks) | $300 – $700 |
| Chimney waterproofing | $250 – $600 |
| Flashing repair | $300 – $800 |
| Crown rebuild | $500 – $1,200 |
| Partial chimney rebuild | $2,500 – $6,000 |
What moves the number within a range: how many bricks need replacing, whether the repair is on two flues or one, roof height and access on a tight St. George lot, and whether a liner restoration like HeatShield is part of the job. The estimate is free and the price is set per job, so call (855) 551-0049 and we’ll come out and put it in writing.
We Also Serve Cities Near St. George
We work across the north and east shores of Staten Island and into Brooklyn. Beyond St. George, we cover Stapleton, Rosebank, South Beach, and Bay Ridge. If you’re on the border between neighborhoods, call and we’ll tell you whether you’re in our service area. Our chimney repair team schedules by job, and the estimate is always free.
Serving St. George, NY – Our Local Coverage Area
We serve St. George and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Repair in St. George
You can’t know for sure from the street, and that’s exactly why a camera inspection matters. On many St. George rowhouse blocks, adjacent buildings share a chimney stack, but whether the flues are truly shared or just side by side in the same masonry has to be confirmed from the roof and with a camera run through the flue. We check the offset flues and the party-wall side during a Level 2 inspection and show you what the camera sees. Call (855) 551-0049 to book an inspection – the estimate is free.
Water and freeze-thaw cycles are the cause, and St. George’s humid coastal climate and cold winters are the accelerator. The brick face absorbs moisture, the temperature drops, the water expands, and the face pops off. A failed crown or flashing lets more water in, and repointing with the wrong mortar mix traps it inside, which makes the spalling worse. The fix is to stop the water first, then replace the brick and repoint with a matched mix. Call (855) 551-0049 for a free estimate.
Yes, if the cause is in the shared stack, and on a St. George rowhouse that’s often where it starts. A cracked flue liner or a deteriorated smoke chamber in a shared stack can let smoke – and carbon monoxide – from one unit seep into the adjacent one. The repair depends on what the camera shows: HeatShield resurfacing for liner cracks, a rebuilt smoke chamber, or repointing the shared masonry. We coordinate access with the neighbor so both flues stay working. Call (855) 551-0049 to talk it through – estimates are free.
Once a year is the standard, and in St. George’s climate it earns its keep. Annual inspection and cleaning catch the water intrusion and flue deterioration that the humid coastal air and freeze-thaw winters drive, and a homeowner who watches that yearly avoids the costly rebuild later. If you burn wood regularly, keep to the yearly schedule. If the chimney has sat dormant for decades, get a camera inspection before you reconnect any appliance. Call (855) 551-0049 to schedule – the estimate is free.
Repointing means grinding out the failed mortar and packing in new mortar that matches the original; tuckpointing is a finishing technique where a contrasting mortar is drawn over the joint to give a crisp, uniform look. On St. George’s older brick buildings, the important part isn’t the finish, it’s the mortar mix. A mix that’s harder than the original lime mortar traps moisture in the wall and accelerates spalling, so we match the mix to the building first and pick the finish second. Call (855) 551-0049 for an honest read on what your chimney needs.
Get a Free Chimney Repair Estimate in St. George
If your chimney is showing its age, get it looked at by a chimney-only specialist before the next freeze. We inspect with a camera, show you what we find, and tell you what can wait. No liner or masonry work gets recommended without evidence you can see. Call (855) 551-0049 for a free estimate across St. George and the surrounding Staten Island neighborhoods. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Bay Ridge.